Cracked, chipped, stained, or just worn out? You don't have to tear out your shower base and start over. Tubrise refinishes shower bases across St. Petersburg and the Tampa Bay area—restoring a smooth, glossy, like-new surface in a single day for far less than a full replacement.
Our simple, one-coat process
Smart homeowners refinish instead of replace. Here's why:
Preparation
We clean and de-gloss the surface, fill any minor chips or cracks, and mask off the surrounding area
One pour-on coat
We apply a single, thick, self-leveling coat of ArmoGlaze, approximately 1 mm thick (about 10 times thicker than a sprayed coating). We pour it on rather than spray it, so no overspray and no fumes fill your home.
Like-new finish
The finish cures in about 24 hours and you're back in the shower — with a hard, mirror-smooth surface built to last.
WHAT WE REFINISH
Fiberglass shower base refinishing
Dulls over time; we clean, repair, and apply a fresh finish.
Cast iron and steel shower base reglazing
Sturdy but chips and rusts; we repair, de-rust, and recoat.
Acrylic, Concrete, Terrazzo shower base refinishing
Durable but scratches; refinishing brings back the shine.
Why homeowners choose our pour-on finish
Smart homeowners refinish instead of replace. Here's why:
Shower Base Refinishing in Tampa Bay
Serving St. Petersburg, Clearwater, Largo, and the wider Tampa Bay area — we restore worn shower bases right where they sit, no removal needed.
Odorless, Non-Toxic Process
Our pour-on enamel is completely odorless and non-toxic. Stay home while we work — safe around kids and pets, with no fumes or dust.
One-Coat Pour-On Finish
A single, thick, self-leveling coat of epoxy paint — about 1 mm thick, roughly 10× thicker than spray. No overspray, no thin peeling layer.
Cracked & Chipped Base Repair
We fill minor chips and cracks during prep, so you get a smooth, even surface — not paint sprayed straight over the damage.
Fiberglass, Acrylic & Cast Iron
We refinish every common base: fiberglass, acrylic, ceramic tile, concrete, terrazzo, cast iron, and steel — each prepped for its specific material.
Done in One Day
Most shower bases are finished in a single visit and cure in about 24 hours, leaving a durable, mirror-smooth surface that lasts 15–20 years.
Example of how our process looks.
The Pour-On Difference
Traditional refinishing uses spray guns that leave a thin, easily chipped layer of paint. We do it differently. Tubrise uses a high-quality, two-part epoxy enamel applied by a pour-on method, creating a thick, durable coating — far heavier than spray-on:
- Smooth, glossy finish that mimics real porcelain
- Resists chipping, cracking, and peeling
- Outlasts spray-on refinishing by years
What You Get
- Does not require dismantling
- Savings of thousands vs. replacement
- Ready to use in ~24 hours
- No demolition of walls
- No re-tiling needed
- 100% guarantee
